Custom Made Jeep Dodge Yamaha Ford Toyota Trailer Wiring Harness
The length of trunk line and protective casing should not be less than 100mm, and be a multiple of 10. Such as: 100mm, 110mm, 120mm, etc.
- Product Introduction
Product Parameters
| Product | Custom Automotive Wiring Harness |
| Application | Automotive Industry,Truck Industry,Aftermarket Repair,Motorcycle Industry,etc |
| Custom Process | 1.Provide us the samples,drawing,wire diagram,connector original number.etc. |
| 2.Sample's engineering analysis | |
| 3.Make sample for evalation | |
| 4.Start the mass production after sample approval | |
| 5.100% QC inspection | |
| 6.Arrange the shipment | |
| Wire Specification | As per your requirements |
| Connector Specification | We have verious connector for your choose. |
| Manufacturing technique | As per your requirements or samples |
| MOQ | We can accept small order if we have stock |
| Delivery Time | 7-15 working days.For large quanity,please contact us for details |
Technical Data
This is custom made jeep dodge yamaha ford toyota trailer wiring harness, they will fit any application with the same connector.
Built with H1 H8 female connectors,seals,terminals
polyethylene wire for superior high temperature and abrasion resistance
Perfect match for the car
Technical sharing
Basic requirements for automotive wiring harnesses
1. Harness dimensions shall meet the following requirements:
The length of trunk line and protective casing should not be less than 100mm, and be a multiple of 10. Such as: 100mm, 110mm, 120mm, etc.
The length of branch line should not be less than 30mm.
The distance between contacts and branch points should not be less than 20mm.
When the connection between the wire and the terminal needs to be equipped with an insulating sleeve, the length of the insulating sleeve shall not be less than 20mm.
The contact shall meet the following requirements:
The conductor shall not be broken and the cross section of the contact shall conform to the requirements of Appendix A.
When using brazing method, corrosive flux is not allowed. Solder joints should be smooth, do not allow leakage, penetration, flux inclusion and other defects.
When the solderless welding method is adopted, oxidation, wire breaking, defect and melting of insulation layer are not allowed on the surface of the welding place. As shown in the figure below, the welded and unwelded transition part a should be circular arc, and the unwelded conductor end can be seen in zone b.
The contact should be firm and should not be damaged or detached under the specified tension.
Hot Tags: custom made jeep dodge yamaha ford toyota trailer wiring harness, China, manufacturers, suppliers, factory, custom, wholesale, low price,
